So I was thinking of adding USBC PD to my ender 3v2 for a off grid setup. Is it possible or have I gone mad with USBC? I know it’s possible with my old monoprice select mini because of its low power requirements.

  • empireOfLove@lemmy.one
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    That would be difficult because you would need to somehow separate the power control MOSFET’s from the driver boards so that the controller can still feed them a PWM signal for temp control, but the power would be provided from a separate dedicated usbPD driver board for each set of MOSFETs. At that point it’s really not worth the effort.

    • evidences@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      11 months ago

      Could you not just do something similar to what printers with mains heated beds do and run the bed/hotend heater to a relay and different power bank?

      • empireOfLove@lemmy.one
        link
        fedilink
        English
        arrow-up
        1
        ·
        11 months ago

        Sure, but on these fully DC printers all the power control hardware is integrated into the main board and supplied from a single main power rail. You’d have to basically build a separate power control board with that would allow you to isolate those MOSFET’s on their own power rail and then jump the PWM control signal over to it from the main board. Decent amount of electronics knowledge and skill required to pull that off.

        • evidences@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          11 months ago

          Yeah but why would you need to do that? You’re isolating the second power source behind a relay and switching it using the normal controller.