I’m wondering if anyone who uses Drivepool with Snapraid can help with a question I have. I’ve searched all over and can’t find an answer.

I have a Drivepool set up with some aging drives, mainly for Emby as well as photos etc. My essential files are duplicated as well as backed up on Backblaze but the media files are just freeballing.

I would like to set up a parity drive using Snapraid for the media files since it would be a PIA to figure out whats missing and then replace it in the event of a drive failure. Snapraid would just be for these media files which are static and don’t get modified.

I understand automatic rebalancing should be turned off so files do not get moved around too much for Snapraid.

My question is I also have Stablebit Scanner and one of the options is automatic evacuation if it detects a drive failure.

Am I right to assume I should disable this since it would try to remove files off the dying drive to the remaining drives as it would screw up the parity?

Typing it out I think I know the answer but just want confirmation as I’ve never used a RAID config before.

  • fediverser@alien.topEnglish
    1·
    11 months ago

    This post is an automated archive from a submission made on /r/DataHoarder, powered by Fediverser software running on alien.top. Responses to this submission will not be seen by the original author until they claim ownership of their alien.top account. Please consider reaching out to them let them know about this post and help them migrate to Lemmy.

    Lemmy users: you are still very much encouraged to participate in the discussion. There are still many other subscribers on [email protected] that can benefit from your contribution and join in the conversation.

    Reddit users: you can also join the fediverse right away by getting by visiting https://portal.alien.top. If you are looking for a Reddit alternative made for and by an independent community, check out Fediverser.