After tuning my vref, the printer was missing steps still. I pulled the trigger and am swapping from the 4.2.2 to the 4.2.7 creality board to see if that resolves the issue.
While i was in there, I figured I’d put another z axis motor on there.
Do you guys have any recommendations on firmware or should I just stick with creality’s?
If you’re feeling adventurous, you could compile Marlin yourself. I did it to use a pin as an “off” signal for my fans, but ended up tinkering with options like linear advance. The set up isn’t too hard, but you need vscode.
I appreciate your confidence in me, but I don’t think up for trying to learn how to deal with it. I don’t do well with troubleshooting firmware/software when things go tits up
It is really easy just follow the marlin docs.