• 0 Posts
  • 443 Comments
Joined 1 year ago
cake
Cake day: July 20th, 2023

help-circle
  • It’s easier to layer tops than bottoms. So shorts with short sleeves covered with a button up long sleeve can be surprisingly practical even though it feels silly. Open the button up when it starts to get a bit warm, and remove it entirely when active in the sun. Large diurnal temperature swings can mean committing some fashion faux pas.





  • I’m not a meteorologist, but I do know a thing or two about plasma.

    Plasma is very short lived. Think on the order of microseconds at atmospheric pressures. So unless there was a massive linear source of power along the whole length, this isn’t plasma.

    The visual effects probably have to do with the fact that the sun was very low. I’m guessing the particle size distribution in that line is notably different from the size of particles in the clouds surrounding it, leading to much stronger reflection of evening light.

    I am curious as to the meteoroligical explanation for the line though.









  • They still think that YouTube and Facebook are representative of the average person. They don’t understand how incredible curated those feeds are. I think that’s where some of the “silent majority” mythos comes from. Everything they see is people agreeing with them, therefore it’s impossible that Joe Biden got more votes in 2020.



  • Did you measure voltage drop across the pump while it’s trying to start up? The voltage will only drop when there’s current being drawn. So with the pump off you would see full supply volts even on a highly resistive line. You could try lugging a battery down to the pump, and jump it to get it started, then remove the battery jumpers but keep the pump running on your main run, then measure the volts across the pump.

    Or you could try to measure the resistance of your wiring with your meter. You would disconnect it from your 12v source, then short the pump side, then measure the ohms across the pair at the source side. Also measure the resistance across your pump windings when it is disconnected, but with the switch on.

    I’ll throw out some example numbers. Say you have a pump that says it needs 6 Amps. Chances are the inrush current is more like 12A. If you measure across the terminals with the pump disconnected from power with the switch closed, you might measure around 1 Ohm. Now if you measure your very long supply line and get 2 Ohms. Then you would only get 12V/(1+2 )Ohms = 4 Amps through the whole system. With the pump drawing 4 Amps you would only see 4V at the pump terminals when it is already running.






  • Those are good addendums, but I’ll add one more qualifier to your nasal rinse suggestion. Never use tap water. Use only distilled water or water that has been boiled. Pharmacies also sell aerosol cans with saline solution, which is what I use for the convenience factor. Then you don’t have to worry as much about sanitized water and mixing up a solution. Saline rinses should also have at least half an hour of being upright before laying down. Don’t do a rinse then immediately lay in bed.

    If budget isn’t tight, all bedding including the allergy covers benefits from getting in duplicate so you can take your time with the laundry. I was a lot worse about washing bedding when remembering late in the day meant there wouldn’t be enough time to wash and dry before bedtime.